Solving V2L problems
If a problem occurs while using the V2L function, the V2L stops and a related messages appears on the instrument cluster.
Check the cause of the message and take an appropriate measure referring to the table below.
|
Message |
Cause |
Measure |
|
V2L finished. Defined charge level reached |
The high voltage battery level reaches the discharging limit set level. |
To use the V2L continuously, make the discharging limit set level lower than the present battery level. (Refer to the "Setting a battery discharging limit when using Vehicle to Load (V2L)" section in this chapter.) |
|
Energy consumption too high. V2L cancelled |
An electrical appliance that exceeds the maximum power output the vehicle can supply is connected. |
Check the total power consumption of the electrical appliance and replace it a product within the V2L maximum power output. |
|
V2L conditions not met |
V2L is stopped for the following reasons:
|
Make sure there are no problems with the V2L connector and the vehicle indoor outlet. |