+ -

Rear combination light replacement

Type A

2C_RearLampOverview

  1. Tail/Stop light
  2. Tail light
  3. Turn signal light
  4. Reverse light
  5. Rear side marker

Stop/Tail light (Outside)

  1. Turn off the engine.

  2. Open the liftgate.

  3. Loosen the light assembly retaining screws with a cross-tip screwdriver.

    ONX4090026

  4. Remove the rear combination light assembly from the body of the vehicle.

  5. Remove the socket from the assembly by turning the socket counterclockwise until the tabs on the socket align with the slots on the assembly.

    ONX4090045

  6. Remove the bulb from the socket by pressing it in and rotating it counterclockwise until the tabs on the bulb align with the slots in the socket. Pull the bulb out of the socket.

  7. Insert a new bulb by inserting it into the socket and rotating it until it locks into place.

  8. Install the socket into the assembly by aligning the tabs on the socket with the slots in the assembly. Push the socket into the assembly and turn the socket clockwise.

  9. Reinstall the light assembly to the body of the vehicle.

Tail light (Inside)

ONX4090027

  1. Turn off the engine.

  2. Open the liftgate.

  3. Remove the service cover using a flat-blade screwdriver.

  4. Remove the socket from the assembly by turning the socket counterclockwise until the tabs on the socket align with the slots on the assembly.

    ONX4090028

  5. Remove the bulb from the socket by pressing it in and rotating it counterclockwise until the tabs on the bulb align with the slots in the socket. Pull the bulb out of the socket.

  6. Insert a new bulb by inserting it into the socket and rotating it until it locks into place.

  7. Install the socket into the assembly by aligning the tabs on the socket with the slots in the assembly. Push the socket into the assembly and turn the socket clockwise.

  8. Reinstall the light assembly to the body of the vehicle.

Turn signal light, Rear fog light, Reverse light

  1. Disconnect the negative battery cable.

    ONX4E090054

  2. Loosen the retaining clips under the bumper and screws on the wheel house trim.

  3. Prey trim under the bumper toward the vehicle.

    Turn signal light

    ONX4EH090006

    Reverse light

    ONX4EH090007

  4. Remove the socket from the assembly by turning the socket counterclockwise until the tabs on the socket align with the slots on the assembly.

  5. Remove the bulb by pulling it straight out.

  6. Insert a new bulb in the socket.

  7. Reinstall the light assembly to the body of the vehicle.

Type B

2C_RearLampOverview_2

  1. Tail/Stop light
  2. Tail light
  3. Turn signal light
  4. Reverse light
  5. Rear side marker

If the LED light does not operate, have your vehicle inspected by an authorized HYUNDAI dealer.

The LED light cannot be replaced as a single unit. A skilled technician should check or repair the LED light, for it may damage related parts of the vehicle.