2C_TowingMount

It’s important to have the correct towbar equipment. Crosswinds, large trucks going by, and rough roads are a few reasons why you’ll need the right towbar. Here are some rules to follow:

• Do you have to make any holes in the body of your vehicle when you install a trailer towbar? If you do, then be sure to seal the holes later when you remove the towbar. If you don’t seal them, carbon monoxide (CO) from your exhaust can get into your vehicle, as well as dirt and water.

• The bumpers on your vehicle are not intended for towbars. Do not attach rental towbars or other bumper-type towbars to them. Use only a frame-mounted towbar that does not attach to the bumper.

• A HYUNDAI trailer towbar accessory is available at an authorised HYUNDAI dealer.

• We recommend only genuine HYUNDAI towbars (these towbars are made and tested in Austraila/NZ for local conditions).

You should always attach chains between your vehicle and your trailer.

Instructions about safety chains may be provided by the towbar manufacturer or trailer manufacturer. Follow the manufacturer’s recommendation for attaching safety chains. Always leave just enough slack so you can turn with your trailer. And, never allow safety chains to drag on the ground.

If your trailer is equipped with a braking system, make sure it conforms to your country’s regulations and that it is properly installed and operating correctly.

If your trailer weighs more than the maximum trailer weight without trailer brakes loaded, then it needs its own brakes and they must be adequate. Be sure to read and follow the instructions for the trailer brakes so you’ll be able to install, adjust and maintain them properly. Be sure not to modify your vehicle’s brake system.