Smart key
Your HYUNDAI may be equipped with a smart key that can be used to lock or unlock the doors, trunk, and start the engine.
OCN7053005
OCN7053004
- Door lock
- Door unlock
- Trunk Open
- Panic
- Remote Start (if equipped)
Button type
OCN7050078
To lock:
-
Close all doors.
-
Have the smart key with you.
-
Press the door handle button or press the Door Lock button (1) on the smart key. The chime sounds and hazard warning lights blink. Also, the side view mirrors fold if On door unlock or On driver approach is selected from the Settings menu in the instrument cluster or infotainment system (if equipped).
-
Make sure the doors are locked by pulling the outside door handle.
Touch sensor type
OCN7053003
To lock:
-
Close all doors, hood, and trunk.
-
Have the smart key with you.
-
Touch the outer part of the door handle on or near the handle detent for about 1 second or until you hear the door locks actuate. The chime sounds and hazard warning lights blink. Also, the side view mirrors fold if On door unlock or On driver approach is selected from the Settings menu in the instrument cluster or infotainment system (if equipped).
-
Make sure the doors are locked by pulling the outside door handle.
-
The door handle button or touch sensor only operates when the smart key is within 28-40 in. (0.7-1 m) from the outside door handle.
-
If you lock the door with the touch sensor, the doors cannot be unlocked with the touch sensor within 3 seconds.
-
If you lock the doors using the door handle button or touch sensor, the doors are not locked under the following circumstances:
-
The Smart Key is in the vehicle.
-
The Button Start ignition switch is in the ACC or ON position.
-
Any door is open (except for the trunk).
-
If this occurs, a chime sounds for about 3 seconds. Check the vehicle before attempting to lock the vehicle again.
Before you leave your vehicle with the Smart Key, verify that your vehicle is locked. When using the touch sensor on the front door handle, listen to hear that the lock has actuated, and then pull the handle within 3 seconds to confirm the doors are locked.
(If it has been longer than 3 seconds, verify the doors are locked by pressing the lock button on the Smart Key. You can hear a single beep.)
Do not leave the Smart Key in your vehicle with children that are unattended or unsupervised.
Children could unintentionally press the Button Start ignition switch or could operate the power windows or other vehicle controls or even cause the vehicle to move. This may result in serious injury or death.
Button type
OCN7050078
To unlock:
-
Have the smart key with you.
-
Press the door handle button or press the Door Lock button (2) on the smart key. The chime sounds and hazard warning lights blink two times. Also, the side view mirrors unfold if On door unlock or On driver approach is selected from the Settings menu in the instrument cluster or infotainment system (if equipped).
-
If you unlock the doors using the passenger side door handle, all the doors are unlocked. If you unlock the doors using the driver side door handle, either the driver's side door is unlocked or all the doors are unlocked depending on the setting for the Two Press Unlock feature. Change the Driver Door unlock mode by referring to "Setting the Two Press Unlock feature".
-
Touch sensor type
OCN7050093N
To unlock:
-
Have the smart key with you.
-
Grab the door handle to activate the door unlock touch sensor. The chime sounds and hazard warning lights blink two times. Also, the side view mirrors unfold if On door unlock or On driver approach is selected from the Settings menu in the instrument cluster or infotainment system (if equipped).
-
If you unlock the doors using the passenger side door handle, all the doors are unlocked. If you unlock the doors using the driver side door handle, either the driver's side door is unlocked or all the doors are unlocked depending on the setting for the Two Press Unlock feature. Change the Driver Door unlock mode by referring to "Setting the Two Press Unlock feature".
-
-
The door handle button or touch sensor only operates when the smart key is within 28-40 in. (0.7-1 m) from the outside door handle.
-
After unlocking the doors, the doors are locked automatically after 30 seconds unless a door is opened.
Setting the Two Press Unlock feature
You can activate or deactivate the Two Press Unlock feature from the Settings menu in the instrument cluster or infotainment system. Select:
-
User Settings > Door > Two Press Unlock (for instrument cluster type)
-
Settings > Vehicle > Door > Two Press Unlock (for infotainment system type)
-
For more information on the cluster type Settings menu, refer to the "Cluster display (Type A)" section in chapter 4.
-
The infotainment system may change after software updates. For more information, refer to the infotainment system manual.
Setting the door lock/unlock prevention feature
The doors may lock or unlock if the touch sensor of the outside door handle is recognized while washing your vehicle or due to heavy rain.
To prevent unintentional door lock or unlock:
Press the lock button on the smart key and immediately press the unlock button along with the lock button for more than 4 seconds. The hazard warning lights blink four times. At this time, the doors do not lock or unlock even though the touch sensor is touched on the outside door handle. To deactivate the function, press the door lock or unlock button on the smart key.
-
During a car wash or rain, in order to minimize unintentional operation of the touch sensor, the touch sensor may become insensitive. This is not a malfunction.
-
The doors may not lock or unlock in the following situations.
-
If the touch sensor is touched with gloves on.
-
If the door is suddenly approached.
-
To open:
-
Make sure you have the smart key in your possession.
-
Press the trunk open/close button on the vehicle or press and hold the trunk Open button (3) on the smart key for more than 1 second. The hazard warning lights blink twice and the trunk is unlocked.
-
Pull up on the trunk to open.
The horn sounds and the hazard warning lights blink for about 30 seconds if this button (4) is pressed for more than 1 second. To stop the horn and lights, press any button on the smart key.
To start the vehicle remotely:
-
Press the door lock button on the smart key. You must be within about 32 ft. (10 m) from the vehicle.
-
Press and hold the Remote Start button (5) on your smart key for more than 2 seconds. You must press the button within 4 seconds from when you have pressed the door lock button. The hazard warning lights blink and the engine starts.
-
To turn off the engine, press the Remote Start button (5) once.
-
In case of the manual operation, the climate control system will be maintained even when the engine is turned OFF. However, the automatic operation is set to 72 °F (22 °C).The climate control system remain set before the engine is turned OFF.
-
The engine turns off if you do not get on the vehicle within 10 minutes after remotely starting the vehicle.
-
The Remote Start button may not operate if the smart key is not within 32 ft. (10 m) from the vehicle.
-
The vehicle does not remotely start if the hood or trunk is open.
-
Do not idle the engine for a long time.
Some models are equipped with a Button Start ignition switch instead of a key cylinder. You can leave your smart key in your pocket or purse when you start your vehicle.
For more information, refer to the "Push button start ignition switch" section in chapter 6.
If the smart key is not moved for some time, the detection function for smart key operation will pause. Lift the smart key to activate the detection again.
To prevent damaging the smart key:
-
Keep the smart key in a cool, dry place to avoid damage or malfunction. Exposure to moisture or high temperature may cause the internal circuit of the smart key to malfunction. This may not be covered under warranty.
-
Avoid dropping or throwing the smart key.
-
Protect the smart key from extreme temperatures.
If the smart key does not operate normally, you can lock or unlock the driver's door by using the mechanical key.
OCN7053008
Turn the knob (2) of the mechanical key after removing the key protector (1).
After using the mechanical key, turn the key knob (2) and insert the key protector (1).
A key cylinder is located on the driver side door handle hidden behind a plastic cover. Using the mechanical key, push and hold the key cylinder cover release button located on the underside of the door handle refer to "Door locks" section in this chapter.
Use the mechanical key inserted into the release button slot to open the cover outward. Once the cover is off, the mechanical key can be inserted into the key cylinder to lock or unlock the vehicle.
To reinstall the mechanical key into the smart key, put the key into the key hole and push inward until a click sound is heard.
A maximum of two smart keys can be registered to a single vehicle. If you happen to lose your smart key, immediately take the vehicle and remaining key to your authorized HYUNDAI dealer or tow the vehicle, if necessary.
The smart key may not work if any of the following occur:
-
The smart key is close to a radio transmitter such as radio station or airport that may interfere with normal operation of the transmitter.
-
The smart key is near a mobile two way radio system or a mobile phone.
-
Another vehicle's smart key is being operated close to your vehicle.
-
If your windows are tinted, especially with metallic window tint, it may cause frequency interference, reducing the smart key operating range.
-
The vehicle battery is discharged.
-
Connecting an external device to the power outlet and placing the smart key near the external device.
If the smart key does not work correctly, open and close the door with the mechanical key. To start the engine, press the Button Start ignition switch directly with the smart key. If you have a problem with the smart key, contact an authorized HYUNDAI dealer.
If the smart key is in close proximity to your mobile phone, the signal could be blocked by your mobile phone's operational signals. This is specifically relevant when the phone is active such as making and receiving calls, text messaging, and/or sending/receiving emails. If possible, avoid keeping the smart key and your mobile phone in the same location such as pants or jacket pocket to avoid interference between the two devices.
-
Keep the smart key away from electromagnetic materials that may block electromagnetic waves to the key surface.
-
Always have the smart key with you when leaving the vehicle. If the smart key is left near the vehicle, the vehicle battery may be discharged.
Battery Type: CR2450
To replace the battery:
-
Put the slim tool into the key hole (1) to pry open the rear cover of the smart key.
2C_RemoveSmartKeyCover
-
Remove the old battery and insert a new battery. Make sure the battery position is correct. An improperly positioned battery may discharge the battery, causing smart key failure.
2C_ReplaceSmartKeyBattery
-
Reinstall the rear cover of the smart key.
If you suspect your smart key might have sustained some damage, or you feel your smart key is not working correctly, contact an authorized HYUNDAI dealer.
This product contains a button battery.
If swallowed, a lithium button battery can cause severe or fatal injuries within 2 hours. Keep batteries out of reach of children.
If you think batteries may have been swallowed or placed inside any part of the body, seek immediate medical attention.
An inappropriately disposed battery may be harmful to the environment and human health. Always dispose of a used battery according to your local law(s) or regulations.