+ -

Rear combination lamp replacement

2C_RearLampOverview

  1. Tail/Stop lamp
  2. Turn signal lamp (LED or bulb)
  3. Back up lamp

If the LED lamp does not operate, we recommend that your vehicle be inspected by an authorised HYUNDAI dealer.

The LED lamp cannot be replaced as a single unit. A skilled technician should check or repair the LED lamp, for it may damage related parts of the vehicle.

Replacing reversing lamps (bulb)

  1. Apply the parking brake and turn off the engine.

  2. Turn off all the lamps and open the boot.

    2C_BackupLampChange1

  3. Remove the clip on the boot panel.

  4. Remove the socket from the assembly by turning the socket anti-clockwise until the tabs on the socket align with the slots on the assembly.

    2C_BackupLampChange2

  5. Remove the bulb from the socket by pressing it in and rotating it anti-clockwise until the tabs on the bulb align with the slots in the socket. Pull the bulb out of the socket.

  6. Install a new bulb and reinstall in the reverse order.

Replacing turn signal lamp (bulb)

  1. Turn off all the lamps and open the boot panel.

  2. Remove the service cover by pulling out the service cover.

    2C_RepeaterLampChange1

  3. Remove the socket from the assembly by turning the socket anti-clockwise until the tabs on the socket align with the slots on the assembly.

    2C_RepeaterLampChange2

  4. Remove the bulb from the socket by pressing it in and rotating it anti-clockwise until the tabs on the bulb align with the slots in the socket. Pull the bulb out of the socket.

  5. Install a new bulb and reinstall in the reverse order.