Cluster Display Messages

  • Do not drive with a warning message displayed.

  • If a warning message does not go off after taking measures, have your vehicle immediately inspected and repaired by an authorized HYUNDAI dealer.

Vehicle is On

This message appears if you open the driver's door when the gear is in P (Park) and the Engine Start/Stop button in the ON or START position.

Turn the engine off before leaving the vehicle.

Shift to P

This message appears if the Engine Start/Stop button is pressed to the OFF position without the gear in the P (Park) position.

If this occurs, the Engine Start/Stop button goes to the ACC position.

Vehicle is in N. Press START button and shift to P.

This message appears if you try to turn off the vehicle with the gear in N (Neutral).

Shift the gear to P (Park) with the Engine Start/Stop button in the ON position and press the Engine Start/Stop button.

Low key battery

When the Engine Start/Stop button is pressed to the OFF position, a message may appear, indicating the internal battery of the smart key is low. Replace the smart key battery.

Press brake pedal to start vehicle

This message appears if the Engine Start/Stop button is pressed repeatedly without depressing the brake pedal.

Start the vehicle by depressing the brake pedal and then pressing the Engine Start/Stop button.

Key not in vehicle

This message appears if the smart key is not in the vehicle when you have left the vehicle with the Engine Start/Stop button in the ON or START position.

Always turn off the engine before leaving your vehicle.

Press START button again

If you cannot start the vehicle after the Engine Start/Stop button is pressed, attempt to start the engine by pressing the Engine Start/Stop button again.

If the warning message appears each time you press the Engine Start/Stop button, have your vehicle inspected by an authorized HYUNDAI dealer.

Press START button with key

This message appears if the smart key is not detected when you press the Engine Start/Stop button after accessing with the smart key.

Check BRAKE SWITCH fuse

This message appears if the brake switch fuse is disconnected. Replace the fuse before starting the engine.

If that is not possible, start the engine by pressing the Engine Start/Stop button for 10 seconds in the ACC position.

Shift to P or N to start engine

This message appears if you try to start the engine in any other position except P (Park) or N (Neutral). Start the engine with the vehicle in P (Park) with your foot depressing the brake pedal.

You can start the engine with the gear in N (Neutral).

Battery discharging due to external electrical devices

This message appears if the vehicle battery voltage is low or if a current draw is detected that could drain the vehicle battery.

Do not connect any external electronic devices to the battery system or battery discharge may occur.

If this message appears on the cluster and there are no other external electronic devices connected to the vehicle, have your vehicle inspected by an authorized HYUNDAI dealer.

Door, Hood, Liftgate open indicator

2C_DoorOpenWarning

This warning appears if any door, hood, or liftgate is left open. The warning indicates which door is open on the cluster display.

Before driving the vehicle, confirm the door, hood, and liftgate are fully closed.

Sunroof open indicator

2C_SunroofOpenWarning

This warning appears if you turn off the engine when the sunroof is open.

Close the sunroof securely before leaving your vehicle.

Low tire pressure
Type A

2C_TireLowPressureWarning_1

Type B

2C_TireLowPressureWarning

This warning message appears if the tire pressure is low. The corresponding tire on the vehicle is illuminated.

For more information, refer to Tire Pressure Monitoring System (TPMS).

Lights

2C_LightMode

This indicator displays which exterior light is selected using the lighting control.

You can activate or deactivate wiper/lights display function from the Settings menu in the infotainment system. Select Setup > Cluster/Head-Up Display > Cluster > Content Selection > Wiper/Lights Display.

Wiper
Front

2C_FrontWiperMode

Rear

2C_RearWiperMode

This indicator displays which wiper speed is selected using the wiper control.

You can activate or deactivate wiper/lights display function from the Settings menu in the infotainment system. Select Setup > Cluster/Head-Up Display > Cluster > Content Selection > Wiper/Lights Display.

The infotainment system may change after software updates. For more information, refer to the user's manual provided in the infotainment system and the quick reference guide.

Low washer fluid

This message appears if the washer fluid level in the reservoir is nearly empty. Have the washer fluid reservoir refilled.

Engine overheated

This message appears when the engine coolant temperature is above about 248 °F (120 °C). The engine is overheated and may be damaged.

If your vehicle is overheated, refer to If the Engine Overheats.

If your vehicle is overheated, refer to 'In Case of Vehicle Malfunction' section in chapter 8 of the complete Owner's Manual.

Check headlight

This message appears if the headlights are not operation properly. Replace the burned out bulb with a new one with the same wattage rating.

Check turn signal

This message appears if the turn signal lights are not operating properly.

Replace the burned out bulb with a new one with the same wattage rating.

Check headlight LED

This message appears if there is a problem with the LED headlight. Have your vehicle inspected by an authorized HYUNDAI dealer.

Check Active Air Flap System

This warning message appears in the following situations:

  • There is a malfunction with the actuator flap.

  • There is a malfunction with the actuator air flap controller.

  • The air flap does not open.

When all of the above conditions are fixed, the warning disappears.

Place digital key on the wireless charger to keep the vehicle running

If the vehicle is remotely started and Start Vehicle is deselected from the Settings menu in the infotainment system for Driver 1 and Driver 2, this message will be displayed for up to 30 seconds when a door is opened after unlocking the doors with a digital key.

To drive your vehicle, place the registered digital key on the wireless charger, when this message appears.

Place digital key on the wireless charger

If the vehicle is remotely started and Start Vehicle is selected from the Settings menu in the infotainment system for Driver 1 or Driver 2, this message will be displayed for up to 30 seconds when a door is opened after unlocking the doors with a digital key or the Blue Link app.

To drive your vehicle, place the registered digital key on the wireless charger, when this message appears.

Verify digital key then press the START button

This message is displayed for a few seconds and the immobilizer k indicator light will blink for 10 seconds after the message 'Press START button with key' is displayed for a few seconds if the smart key is not in the vehicle or not detected, the digital key is not placed on the wireless charger, or your fingerprint is not verified when you press the Engine Start/Stop button.

To start the vehicle, place a registered digital key on the wireless charger and then press the Engine Start/Stop button.

Check user authentication system

This message is displayed if there is a problem with the digital key system. Have the system inspected by an authorized retailer of HYUNDAI dealer.