This indicator illuminates:

When the vehicle is ready to be driven.

• ON: Normal driving is possible.

• OFF: Normal driving is not possible, or a problem has occurred.

• Blinking: Emergency driving.

When the indicator goes off or blinks, there is a problem with the system. In this case, have your vehicle inspected by an authorized HYUNDAI dealer.

This warning light illuminates:

• When the Start/Stop button is in the ON position. The Service warning light illuminates for 3 seconds and then goes off.

• When there is a problem with related parts of the electric vehicle control system, such as sensors, etc.

When the warning light illuminates while driving, or does not go off after starting the vehicle, have your vehicle inspected by an authorized HYUNDAI dealer.

This indicator light illuminates:

When the power is limited for the safety of the high-powered parts of an electric vehicle. The power is limited for the following reasons:

• The high voltage battery level is too low or voltage is decreasing

• The temperature of the high voltage battery is too high or too low

• The temperature of the motor is high

This warning light illuminates:

When the high voltage battery level is low.

Charge the high voltage battery as soon as possible.

This warning light illuminates:

• When the Start/Stop button is in the ON position. The Airbag warning light illuminates for 3-6 seconds and then goes off.

• When there is a malfunction with the SRS.

  If the Airbag warning light remains illuminated while driving, have the vehicle inspected by an authorized HYUNDAI dealer.

This warning light illuminates:

When the regenerative brake does not operate and the brake does not perform well. This causes the Brake Warning light (red) and Regenerative Parking Brake Warning Light (yellow) to illuminate simultaneously.

In this case, drive safely and have your vehicle inspected by an authorized HYUNDAI dealer.

The operation of the brake pedal may be more difficult than normal and the braking distance can increase.

This warning light illuminates:

When the Start/Stop button is in the ON position. The Parking Brake warning light illuminates for about 3 seconds and then goes off once the parking brake is released.

• Whenever the parking brake is applied.

• Whenever the brake fluid level in the reservoir is low.

  • If the warning light illuminates with the parking brake released, it indicates the brake fluid level in the reservoir is low.

• When the regenerative brake does not operate.

If the brake fluid level in the reservoir is low:

1. Drive carefully to the nearest safe location and stop your vehicle.

2. With the motor stopped, check the brake fluid level immediately and add fluid as required (For more information, refer to the “Brake Fluid” section in chapter 9). After adding brake fluid, check all brake components for fluid leaks. If a brake fluid leak is found, or if the warning light remains on, or if the brakes do not operate properly, do not drive the vehicle. Have the vehicle inspected by an authorized HYUNDAI dealer.

Dual-diagonal braking system

Your vehicle is equipped with the dual-diagonal braking system. This means you still have braking on two wheels even if one of the dual systems fails.

With only one of the dual systems working, more than normal pedal travel and greater pedal force are required to stop the vehicle.

Also, the vehicle does not stop in a short distance if only a portion of the braking system is working.

This warning light illuminates:

• When the Start/Stop button is in the ON position. The ABS warning light illuminates for about 3 seconds and then goes off.

• Whenever there is a malfunction with the ABS.

  The hydraulic braking system still operates even if there is a malfunction with the ABS.

  If the ABS warning light remains illuminated while driving, have the vehicle inspected by an authorized HYUNDAI dealer.

This warning light illuminates:

• When the Start/Stop button is in the ON position. The Motor Driven Power Steering warning light illuminates for about 3 seconds and then goes off.

• Whenever there is a malfunction with Motor Driven Power Steering.

  If the MDPS warning light remains illuminated while driving, have the vehicle inspected by an authorized HYUNDAI dealer.

This warning light illuminates:

If a malfunction is detected in any of the following:

• Forward Collision-Avoidance Assist malfunction

• Forward Collision-Avoidance Assist radar blocked

• Blind-Spot Collision-Avoidance Assist malfunction

• Blind-Spot Collision-Avoidance Assist radar blocked

• LED headlight malfunction

• High Beam Assist malfunction

• Smart Cruise Control malfunction

• Smart Cruise Control radar blocked

• Tire Pressure Monitoring System (TPMS) malfunction

If the issue is resolved, the Master Warning Light turns off.

This warning light illuminates:

• When the Start/Stop button is in the ON position. The EPB warning light illuminates for about 3 seconds and then goes off.

• Whenever there is a malfunction with EPB.

  If the EPB warning light remains illuminated while driving, have the vehicle inspected by an authorized HYUNDAI dealer.

This warning light illuminates:

• When the Start/Stop button is in the ON position. The low tire pressure warning light illuminates for about 3 seconds and then goes off.

• When one or more tires are significantly underinflated. (The location of the underinflated tire appears on the instrument cluster.)

For more information, refer to the “Tire Pressure Monitoring System (TPMS)” section in chapter 8.

This warning light remains ON after blinking for about 60 seconds, or repeatedly blinks ON and OFF in 3 second intervals:

When there is a malfunction with the TPMS.

If this occurs, have the vehicle inspected by an authorized HYUNDAI dealer as soon as possible.

This warning light illuminates:

• When the Start/Stop button is in the ON position. The Forward Safety warning light illuminates for about 3 seconds and then goes off.

• [Yellow] When Forward Safety is deselected or Forward Collision-Avoidance Assist disable/malfunction

• [Blinking Red] When Forward Safety/Forward Cross-Traffic Safety of Forward Collision-Avoidance Assist is operating

If the yellow warning light is still on even after removing foreign material from the front of the sensors after Forward Safety select in settings, have the vehicle inspected by an authorized HYUNDAI dealer as soon as possible.

For more information, refer to the “Forward Collision-Avoidance Assist (FCA)” section in chapter 7.

This indicator light illuminates:

• When you set the ignition switch to the ON position, the yellow indicator light illuminates for about 3 seconds and then goes off

• [Gray] When Lane Keeping Assist operational conditions are not met

• [Continuously Green] When Lane Keeping Assist operational conditions are met

• [Blinking Green] When Lane Keeping Assist is operating

• [Yellow] When Lane Keeping Assist disable/malfunction

If the yellow warning light is still on even after removing foreign material from the front of the sensor after Lane Safety select in settings, have the vehicle inspected by an authorized HYUNDAI dealer as soon as possible.

This warning light illuminates:

Whenever a malfunction with the AWD system is detected.

If this occurs frequently, have the vehicle inspected by an authorized HYUNDAI dealer.

This warning light illuminates:

• When the Start/Stop button is in the ON position. The LED headlight warning light illuminates for about 3 seconds and then goes off.

• Whenever there is a malfunction with the LED headlight.

  If the LED headlight warning light remains illuminated while driving, have the vehicle inspected by an authorized HYUNDAI dealer.

This warning light blinks:

Whenever there is a malfunction with a LED headlight related part.

If this occurs, have the vehicle inspected by an authorized HYUNDAI dealer.

This indicator light illuminates:

When any door or trunk is left open.

This indicator light illuminates:

• When the Start/Stop button is in the ON position. The Electronic Stability Control indicator light illuminates for about 3 seconds and then goes off.

• Whenever a malfunction with ESC system is detected.

  If this occurs, have the vehicle inspected by an authorized HYUNDAI dealer.

This indicator light blinks:

While ESC is operating.

For more information, refer to the “Electronic Stability Control (ESC)” section in chapter 6.

This indicator light illuminates:

• When the Start/Stop button is in the ON position. The Electronic Stability Control indicator light illuminates for about 3 seconds and then goes off.

• When you deactivate ESC system by pressing the ESC OFF button.

This indicator light illuminates for up to 30 seconds:

When the vehicle detects the smart key in the vehicle with the Start/Stop button in the ACC or ON position.

• At this time, you can start the vehicle.

• The indicator light goes off after starting the vehicle.

This indicator light blinks for a few seconds:

When the smart key is not in the vehicle, you cannot start the vehicle.

This indicator light illuminates for 2 seconds and goes off:

If the smart key is in the vehicle and the Start/Stop button is ON, but the vehicle cannot detect the smart key, have the vehicle inspected by an authorized HYUNDAI dealer.

This indicator light blinks:

Whenever there is a malfunction with the immobilizer system, have the vehicle inspected by an authorized HYUNDAI dealer.

This indicator light blinks:

When you operate the turn signal lever.

If any of the following occur, there may be a malfunction with the turn signal system.

• The turn signal indicator light illuminates but does not blink.

• The turn signal indicator light blinks rapidly.

• The turn signal indicator light does not illuminate at all.

If any of these occur, have the vehicle inspected by an authorized HYUNDAI dealer.

This indicator light illuminates:

• When the headlights are on and in the high beam position.

• When the turn signal lever is pulled into the Flash-to-Pass position.

This indicator light illuminates:

When the Parking lights or headlights are on.

This indicator light illuminates:

When the high beam is on with the light switch in the AUTO position.

• [White] When High Beam Assist is ready to operate.

• [Green] When High Beam Assist is operating.

If your vehicle detects oncoming vehicles in front of you, High Beam Assist switches the high beam to low beam automatically.

This indicator light illuminates:

• [White] When you activate Auto Hold by pressing the AUTO HOLD switch.

• [Green] When you stop the vehicle completely by depressing the brake pedal with Auto Hold activated.

• [Yellow] Whenever a malfunction with the Auto Hold is detected. If the AUTO HOLD indicator light remains YELLOW while driving, have the vehicle inspected by an authorized HYNDAI dealer.